The GreaseWeazle 3D printed case has the following features:

• Place holder for GreaseWeazle v4 board.
• Screwless design with optional screw holes for the floppy drive
• Stands to hold a standard Floppy Drive
• Place for a LED at the front
• Vent holes in the back
• Stylish "ribbed" design.

The LED hole is 6.5 mm diameter when looking for an LED make sure this fits.

When installing the GreaseWeazle board you should find it will fit exactly, but may move around when pressure is applied. To solve this, it is recommended to use a small dab of glue from a glue gun in one or two corners.

STL files

Here are some STL files so you can print this case yourself if you like.

• Bottom
• Top